•Materials: Woodblock, Steel Blades, Rubber Foam.
•Measurement: Please check the photo of the woodblock die. If you need the
exact measurement of the shapes please do message.
Create your DIY Leather Jewelry. Compatible with Sizzix Big Shot, Big Shot
Pro, or Big Shot or Plus and Big Kick cutting machines. This is well made and
good quality woodblock cutting die. Will cut through leather, faux leather,
vinyl, fabric & other similar material. Please be caution in using very thick
material. Blades may become distorted. One sheet of leather with each pass only.
******PLEASE CHECK THE MEASUREMENT, SOME DIES THAT ARE WIDER THAN 6 INCHES
WILL FIT ONLY WITH THE PRO OR PLUS OR LONGER THAN 8 INCHES WILL NEED THE
EXTENDED CUTTING PLATES*******
More Information about the Product:
1. This is intended and tested to work with Sizzix Big Shot, Big Shot Plus,
Big Shot Pro, or Big Kick. Will not work with other manual cutting device not
similar to those machines. The woodblock will break or damage if you use those
leather press or hammer.
2. The Steel blades are sharp and covered with black rubber foam. The rubber
foam acts as protection for the steel blades and cushion. Please do not remove
the rubber foam.
4. Some Cutting Dies have holes for convenience. The holes are removable and
can be replace again if prefer. Use wood glue and re-insert the steel holes.
Holes will get clogged so make sure to clean the holes with a pin after each
5.Sandwich the Die with 2 cutting plates, place the rubber foam face up.
******Please make sure to clean the cutting plates after each pass. Change
cutting plates when its bend (may not get a clean cut when using with bended
•Use Pin to clean the holes after each pass. Holes may become loose when its
•If using fibrous materials like cowhide, you may use packing tape. Apply the
tape on the fibrous side of the leather sheet. This will help not get too much
mess or lint in between the rubber foam and steel blades.
*Tassels, Fringes, or similar dies that the blades are too close to each other
will be a tough one to clean. Please use materials that are appropriate for
these types of dies or use the Tape trick. Also, these types of dies, the
rubber foam will cave in after numerous use but will not affect the function of
the die. Do not remove the rubber foam. The rubber foam will protect the steel
blades and your fingers.
7. You may use aluminum foil to re-sharpen the steel blades, try this 3 times.
I will not accept returns on items that are used, opened package, or damaged.
If you have any issue with your purchase please let me know within 3 days and a
return must be made within 5 days. If you pay Shipping, it is non-refundable,
shipping also will be charged when the item was shipped to you and the buyer
pays for the return shipping cost. No return will be accepted after 7 days.